swapfile/etc-init.d-swapfile

#!/bin/sh /etc/rc.common
# (C) 2016 - 2023 Fernao Vellozo
# This is free software under the terms of GPLv3

START=90

EXTRA_COMMANDS="status create"
EXTRA_HELP="	status 	Check service status
	create 	Create a swapfile"

SWPATH="/mnt/routerdata/swapfile"

boot() {
	if [ -f $SWPATH ]; then
		swapon $SWPATH
		logger "swapfile started on boot"
	else
		logger "ERROR: swapfile not found"
	fi
}

start() {
	if [ -f $SWPATH ]; then
		swapon $SWPATH
		logger "swapfile started"
		echo "SwapFile started"
	else
		logger "ERROR: swapfile not found"
		echo "ERROR: SwapFile not found at "$SWPATH
	fi
}

restart() {
	if [ -f $SWPATH ]; then
		swapoff $SWPATH
		swapon $SWPATH
		logger "swapfile stopped, reloading..."
		echo "SwapFile Reloaded"
	else
		logger "ERROR: swapfile not found"
		echo "ERROR: SwapFile not found at "$SWPATH
	fi
}

stop() {
	if [ -f $SWPATH ]; then
		swapoff $SWPATH
		logger "swapfile stopped"
		echo "SwapFile stopped "$SWPATH
	else
		logger "ERROR: swapfile not found"
		echo "ERROR: SwapFile not found at "$SWPATH
	fi
}

create() {
	RAMTOTAL=`fgrep MemTotal /proc/meminfo | awk '{print $2}'`
	SWAPTOTAL=`fgrep SwapTotal /proc/meminfo | awk '{print $2}'`
	if [ $SWAPTOTAL != 0 ]; then                      
		echo "ERROR: Swap already in use, quitting..."
	else
		dd if=/dev/zero of=$SWFILE bs=1024 count=$RAMTOTAL
		mkswap -L SWAPFILE $SWFILE
		chmod 600 $SWFILE
		/etc/init.d/swapfile enable
		logger "SwapFile created"
		echo "SwapFile successfully created, enabled to run after the next reboot"
	fi
}

status() {
	SWAPTOTAL=`fgrep SwapTotal /proc/meminfo | awk '{print $2}'`
	if [ $SWAPTOTAL == 0 ]; then
		echo "No swap memory available"
	else
		echo $SWAPTOTAL "KB of swap are available"
		if [ -f $SWPATH ]; then
			echo "Swapfile is located at "$SWPATH
		else
			echo "Swap memory has been loaded, but not from here"
		fi
	fi
}